< Back to H.R. 5490 (112th Congress, 2011–2013)

Text of To suspend temporarily the duty on certain injection-molded ABS or PP cases or containers to be used for electronic drawing ...

...for electronic drawing toys or electronic games.

This bill was introduced on May 7, 2012, in a previous session of Congress, but was not enacted. The text of the bill below is as of May 7, 2012 (Introduced).

Source: GPO

I

112th CONGRESS

2d Session

H. R. 5490

IN THE HOUSE OF REPRESENTATIVES

May 7, 2012

introduced the following bill; which was referred to the Committee on Ways and Means

A BILL

To suspend temporarily the duty on certain injection-molded ABS or PP cases or containers to be used for electronic drawing toys or electronic games.

1.

Certain injection molded ABS or PP cases or containers to be used for electronic drawing toys or electronic games

(a)

In general

Subchapter II of chapter 99 of the Harmonized Tariff Schedule of the United States is amended by inserting in numerical sequence the following new heading:

9902.01.00Cases or containers (provided for in subheading 4202.99.90), made of injection molded ABS (acrylonitrile butadiene styrene) or PP (polypropylene), specially shaped or fitted for, and with labeling, logo or other descriptive information on the exterior of the case or container indicating an intention to be used for, electronic drawing toys or electronic games of heading 9503 or 9504. FreeNo changeNo changeOn or before 12/31/2016

.

(b)

Effective date

The amendment made by subsection (a) applies to goods entered, or withdrawn from warehouse for consumption, on or after the 15th day after the date of the enactment of this Act.