skip to main content

H.R. 453 (115th): Relief from New Source Performance Standards Act of 2017


The text of the bill below is as of Jan 10, 2018 (Reported by House Committee). The bill was not enacted into law.


IB

Union Calendar No. 378

115th CONGRESS

2d Session

H. R. 453

[Report No. 115–508]

IN THE HOUSE OF REPRESENTATIVES

January 11, 2017

(for himself, Mr. Goodlatte, Mr. Smith of Missouri, Mr. Long, Mr. Lewis of Minnesota, Mr. Emmer, Mr. Sensenbrenner, and Mr. Kind) introduced the following bill; which was referred to the Committee on Energy and Commerce

January 10, 2018

Additional sponsors: Mr. Loebsack, Mr. Grothman, Mr. Luetkemeyer, Mr. Paulsen, Mr. DesJarlais, Mr. Bishop of Michigan, Mr. Hudson, Mr. Graves of Missouri, Mr. Jones, Mr. O'Halleran, Mr. Nolan, Mr. Harper, Mr. Stivers, and Mr. Cramer

January 10, 2018

Committed to the Committee of the Whole House on the State of the Union and ordered to be printed


A BILL

To deem the Step 2 compliance date for standards of performance for new residential wood heaters, new residential hydronic heaters, and forced-air furnaces to be May 15, 2023.


1.

Short title

This Act may be cited as the Relief from New Source Performance Standards Act of 2017.

2.

Step 2 compliance date for standards of performance for new residential wood heaters, new residential hydronic heaters, and forced-air furnaces

(a)

In general

The Step 2 compliance date (as such term is used in the final rule entitled Standards of Performance for New Residential Wood Heaters, New Residential Hydronic Heaters and Forced-Air Furnaces published at 80 Fed. Reg. 13672 (March 16, 2015)) is deemed to be May 15, 2023

(b)

Conforming changes

Not later than 60 days after the date of enactment of this Act, the Administrator of the Environmental Protection Agency shall make such technical and conforming changes to rules and guidance documents as may be necessary to implement subsection (a).

January 10, 2018

Committed to the Committee of the Whole House on the State of the Union and ordered to be printed